Page 1 of 1

can't revert to v 1.8 after v2 demo

Posted: Sun Nov 07, 2010 4:32 pm
by primer
Hi,

I read before installing the demo that I could go back to earlier version by uninstalling the demo. The uninstall seemed to go cleanly but I cant get my printers to work again on v1.8

I was able to enter my turboprint.tpkey file and it shows like it is registered.
I have licence 100060506182309

Can you please confirm what version this should work with and where I can down load the software. Maybe my local copy got corrupted in the swap over.

Although it accpeted the file it seemed to be looking for a *key rather than *tpkey. I recall you changed things a one time , have I got my versions mixed up?

TIA.

PS sorry this should of course have gone in to turboprint section not Fab.

Posted: Mon Nov 08, 2010 9:52 am
by zedonet
Hello,

after uninstallation of version 2 and reinstallation of version 1, TurboPrint 1 should work as before (as far as it is still the same old Linux distribution). Note that current Linux distributions will only work with TurboPrint 2 as most libraries have been changed.
We have stopped the support of TurboPrint 1 as it has been replaced more than two years ago.

Posted: Mon Nov 08, 2010 11:23 am
by primer
thanks for the reply.

I did not have any library issues and the software was working just before I installed the v2 demo. So that is not the problem here.

I do not need detailed tech support at this stage since the software was working but I do not expect to find myself unable to use what I payed you for after following your advice that the demo would not break my existing installation.

Could you please answer my question as to which version the licence I purchased corresponds to and where I can download the tarball?

many thanks.

Posted: Tue Nov 09, 2010 9:23 am
by zedonet
Unfortunately we do not supply TurboPrint 1.x downloads anymore (v1.x has been replaced by TurboPrint 2.x more than two years ago and is no longer supported).

Posted: Tue Nov 09, 2010 10:04 am
by primer
I may well still have the tarball or can find it elsewhere if you would so kind as to tell me what version of the software my licence applies to!

I recall that you changed the keyfiles at some stage during 1.x so I need to know upto what release I can use that with.

I'm not asking for tech support, I just want to know what version my license applies to. That would not seem too much to ask.

regards.

Posted: Tue Nov 09, 2010 10:37 am
by zedonet
Keyfiles of Turboprint 1 are valid for all versions 1.x, i.e. any TurboPrint 1 installation package should work. The only difference between registered and unregistered version is the Turboprint label that is added to the demo version in every printout.