Page 1 of 1

DPI adjustment for printing positive films

Posted: Fri Mar 08, 2019 10:54 pm
by ACES INC
I have turned on the halftones BUT still can not get the software to convert the artwork to halftones before printing. I am using a Epson ET-14000. Are halftones possible? Will I have control over the size of them?

Re: DPI adjustment for printing positive films

Posted: Mon Mar 11, 2019 8:55 am
by zedonet
Hello,

PrintFab can create halftones, but only in the version "PrintFab Pro XL" (if you are using PrintFab in the 30 day trial version, please install as "PrintFab Pro XL").

The options can be found in the PrintFab driver settings, tab "Options", section "Special Settings Screen Printing". Set "Halftone Screen Mode"="Single Black" to enable halftones. You can adjust halftone size (setting "Screen LPI") and angle ("Screen Angle").

Screenprinting-Settings.PNG
Screenprinting-Settings.PNG (9.11 KiB) Viewed 1795 times