CISS & iP4700

Questions on certain printers and applications
Post Reply
klikklak
Posts: 1
Joined: Fri Apr 29, 2011 11:02 am

CISS & iP4700

Post by klikklak »

Hi all,

I've got a CISS system setup to my Canon iP4700. It has no reset chips so at first I had to click yes on a few prompts in windows. Now even after this, it just started complaining about low level of black ink in turboprint. In windows it complained, but printed anyway. In linux it however fails to do this, it just shows spooling and then it skips the job without doing anything. The ink container is half full, so I'm guessing this is a software fault/ink chip fault. Is there anything to do? Did I lose my 30€ in turboprint by still not being able to print within linux?

EDIT: some further info: error message is: Last job failed (0 Pages) 'Premature end of print data'
Printer says 'Ink low' with the yellow ! triangle.

EDIT2: OK, my bad, looks like Okular is having trouble with some of the files.
Post Reply