TurboPrint & PrintFab

Hi,

I've recently moved from Ubuntu to OpenSuse 12.1 x86_64. Under Ubuntu, turboprint was working fine, however under OpenSuse I am unable to detect the printer.

The cups error_log shows the following:

[21/Dec/2011:18:19:45 +0000] No limit for Cancel-Jobs defined in policy allowallforanybody and no suitable template found.
W [21/Dec/2011:18:19:45 +0000] No limit for Cancel-My-Jobs defined in policy allowallforanybody and no suitable template found.
W [21/Dec/2011:18:19:45 +0000] No limit for Close-Job defined in policy allowallforanybody and no suitable template found.
W [21/Dec/2011:18:19:45 +0000] No limit for CUPS-Get-Document defined in policy allowallforanybody and no suitable template found.
W [21/Dec/2011:18:19:45 +0000] No JobPrivateAccess defined in policy allowallforanybody - using defaults.
W [21/Dec/2011:18:19:45 +0000] No JobPrivateValues defined in policy allowallforanybody - using defaults.
W [21/Dec/2011:18:19:45 +0000] No SubscriptionPrivateAccess defined in policy allowallforanybody - using defaults.
W [21/Dec/2011:18:19:45 +0000] No SubscriptionPrivateValues defined in policy allowallforanybody - using defaults.
E [21/Dec/2011:18:21:02 +0000] Returning HTTP Forbidden for CUPS-Get-Devices (ipp://localhost/printers/) from localhost

Any help would be much appreciated.

Thanks in advance.

Sorry - should have mentioned the printer is a Canon MG6150, and I'm trying to connect over the network.

Thanks again

Ah - looks like it's a firewall issue. Disabling the firewall allows the printer to be detected.

Just need to find out what to allow through the firewall, so I can enable it again. I'll have a play....

Sorted! For anyone else experiencing the same problem, I needed only to create a custom rule in the YaST firewall configuration to allow UDP port 8611 through