After upgrading my OS ( Fedora 7 to 8 ) and upgrading turboprint from 1.95-x to 1.96-3, turboprint bug a lot !
xtpconfig for user doesn't start
In console i can see :
Gtk-WARNING **: Failed to load module "libgnomebreakpad.so": libgnomebreakpad.so:
On popup i can read :
Error:
Could not open configuration file!
Start TurboPrint Setup / xtpsetup first!
If i try xtpsetup with root, it always show empty and i must add my printers all the time.
Where can i search ???
Thanks in advance for your help.
Upgrade Fedora 7 to 8 with turboprint 1.95-x to 1.96-3
-
- Posts: 3
- Joined: Sun Nov 11, 2007 2:40 pm
Upgrade Fedora 7 to 8 with turboprint 1.95-x to 1.96-3
Last edited by DonKiShoot on Tue Nov 20, 2007 6:28 pm, edited 1 time in total.
-
- Posts: 3
- Joined: Sun Nov 11, 2007 2:40 pm
Hello,
it should be possible to start xtpconfig once a printer has been added - either using TurboPrint Setup / command line "xtpsetup" or KDE control panel / CUPS (web frontend or lpadmin command line tool).
Can you check if something has been written to the file
/etc/turboprint/turboprint.cfg
after adding a printer from xtpsetup?
it should be possible to start xtpconfig once a printer has been added - either using TurboPrint Setup / command line "xtpsetup" or KDE control panel / CUPS (web frontend or lpadmin command line tool).
Can you check if something has been written to the file
/etc/turboprint/turboprint.cfg
after adding a printer from xtpsetup?
-
- Posts: 3
- Joined: Sun Nov 11, 2007 2:40 pm