PrintFab and Windows 10?
Posted: Mon Dec 21, 2015 12:54 am
Hello,
I just installed PrintFab and am using it to control an Epson R1900. My OS is Windows 10. I have printed from three different programs: Lightroom, Capture 1, and QImage. In all cases, color management is turned off in the software and managed exclusively by PrintFab. I have been using default settings in PrintFab with the appropriate Epson paper selected (e.g., glossy, satin, etc.). In all cases the prints have a very obvious color cast--Usually green, but it seems to vary with subject matter.
The Epson driver works fine, but I would like to have the control that appears to be available in PrintFab.
Does PrintFab work with Windows 10? Is yes, why is it doing such a poor job of printing photos on my Epson? I would think that it should do a reasonable job with the included Epson profiles.
Thanks.
Bob
I just installed PrintFab and am using it to control an Epson R1900. My OS is Windows 10. I have printed from three different programs: Lightroom, Capture 1, and QImage. In all cases, color management is turned off in the software and managed exclusively by PrintFab. I have been using default settings in PrintFab with the appropriate Epson paper selected (e.g., glossy, satin, etc.). In all cases the prints have a very obvious color cast--Usually green, but it seems to vary with subject matter.
The Epson driver works fine, but I would like to have the control that appears to be available in PrintFab.
Does PrintFab work with Windows 10? Is yes, why is it doing such a poor job of printing photos on my Epson? I would think that it should do a reasonable job with the included Epson profiles.
Thanks.
Bob