Page 1 of 1
Pixma Pro10s, BW printing
Posted: Thu Feb 16, 2017 1:02 pm
by gian
hello All,
I have no experience at BW printing, and would like to know if you have any recommendation on papers, settings or tweaks.
So far I tried an Epson Archival matte paper, with gloss optimizer off, and setting for Canon matte, with good result.
The same picture on Epson Premium Glossy paper looked horrible, with a light bronzing effect.
What is your favorite paper for BW?
Re: Pixma Pro10s, BW printing
Posted: Fri Feb 17, 2017 11:17 am
by zedonet
Hello,
you can use any matte or matte fineart paper (smooth fineart, canvas) with good result.
Prints on glossy photo paper will show some bronzing effect.
Prints on semi-glossy, satin or luster paper will have the same high contrast as glossy paper but less bronzing - I recommend to try Canon Luster Paper Pro (LU-101).
One question: in which way was your print on Epson Premium Glossy "horrible" - just the bronzing or also other problems?
Re: Pixma Pro10s, BW printing
Posted: Fri Feb 17, 2017 10:03 pm
by gian
in which way was your print on Epson Premium Glossy "horrible" - just the bronzing or also other problems?
Probably it is just the bronzing that gave a strange, unnatural cast on the image, although it was very evident only with incident light.
I set:
Media: Fineart Matte
Cartridge: Glossoptimzer off
Print Quality: 5-9600 dpi
Color Mode: Gray photo
RGB: Apple bright
Does it sound correct?
Thanks for your support,
-Gian
Re: Pixma Pro10s, BW printing
Posted: Mon Feb 20, 2017 9:11 am
by zedonet
Yes, this is correct for matte paper.
Re: Pixma Pro10s, BW printing
Posted: Wed Oct 18, 2017 7:37 pm
by BarrieGrieve
Probably a little late to comment but I have had some scary results on a Pro-1 with Canson Infinity papers especially Velin Museum Rag, so with careful editing you should get a damn close tonal range from the Pro-10.