TurboPrint & PrintFab

Hi, I'm printing on EMTEC Glossy photo paper with Canon IP6700D printer.
Ink limit printed ranges from 100 to 300. The closest is 100 maybe 125 without smearing.

However Printfab for windows v0.87-2beta does not allow to set ink limit lower than 150, I can't print with such high ink limit.
Please allow to set lower ink limit. When can I expect a fix?

I also installed EPSON 1520 and can't set lower than 150 ink limit too. Is this a bug?

Hello,

thank you for your feedback!

This is actually a "bug" - ink limit range should be 100 - 300% (matching the ink limit test page).
We will fix this in the next release of PrintFab for Windows.

So when I can expect new version of printfab to be released?

The next pre-release is planned for end of October.

Must I wait or perhaps you can email me the hotfix version if you have any, I would like to test the printfab sooner.

A new version PrintFab 0.88beta has just been released - with this version you can set ink limit to 100%.
Download from http://www.printfab.com -> link "Download".