Canon BJC-4650 with D-link DP-301P+

[Ramon Roger]

Dear Friends,

I have the print server “D-Link DP-301P+ “ with the parallel port printer “Canon BJC-4650” and I use Mandriva 2006.0 as operating system.

I have been trying to configure my printer without succes. Firstly I use the print configuration program “Printdrake” with diferents drivers:

BJC-4400 photo: CUPS + Gutenprint r5.0.0-rc1 (en)
CUPS URI: beh_/1/0/30/socket://PS-B48E0B.lan:9100
That works fine but without colors!

BJC-4400: Ghostscript + gutenprint-ijs.5.0
CUPS URI: beh_/1/0/30/socket://PS-B48E0B.lan:9100
That works fine but without colors!

BJC-4650: Ghostscript + bjc800
CUPS URI: beh_/1/0/30/socket://PS-B48E0B.lan:9100
It doesn't work at all. But it works fine even with colors using the parallel port cable.

Finally I try with the Turboprint Free Edition 1.92-2 without any result! (only works using the parallel port cable).
I have runned “xtpsetup” and I have configured my printer as follows:

BJC-4650: Canon_BJC4650 TurboPrint
CUPS URI: socket://192.168.1.3:9100

Short name: tp0
Config Name: Canon_BJC4650
Connection: Socket
Sever Name: 192.168.1.3 (or PS-B48E0B)
Socket: 9100

And if I try to make a Testpage:

First time:
Processing page 1...

Next times if I cancel and try again:
Processing page 1...
Network host '192.168.1.3 is busy; will retry in 10 seconds
Network host '192.168.1.3 is busy; will retry in 15 seconds
(...)

Can you help me?
Thanks you very much

[zedonet]

Hello,

if you can print to your printserver with gutenprint it should also work with TurboPrint using the same CUPS URI

beh_/1/0/30/socket://PS-B48E0B.lan:9100

or

socket://PS-B48E0B.lan:9100

You can also try

Connection: Network printer
Server: PS-B48E0B.lan
Printer: lp0

Please also look into /var/log/turboprint_cups.log for errors (or post the last section of this file if in doubt).