I installed without any problems, then added my HP designjet 130 from TurboPrint Control. When printing a test page, my printer beeps then shuts down. Any ideas what I am doing wrong?
Thanks - that resolved the problem, I can now print! Can you point me to instructions on how to adjust my print margins? The test print and demo page both are printing far off the page on 8-1/2 x 11. Margins in Gimp look fine, resulting print is off the page as well.
Looking at the printed page right side up, it's still printing about 1.8 inches to the right on both the demo page and test page. The pages come out of the printer upside down, so if I use 11x17 paper the entire print is on the page. I did try creating a custom page under "sizes" using both +1.8 & -1.8 left and it appears to have no impact on the print.