Installed the driver on Mac Catalina and a printed test page via my home TCP/IP network. I use a manual rear feed for paper rolls.
I only use 24 inch plain paper rolls to print model airplane plans (from PDF's) in black ink. It isn't clear how to configure a custom paper size that is a roll of paper, rather than a sheet. How do I do this?
- 'Show ink status' gives 'error printer is not responding'. Is this usual?
- How can i be sure I am printing at 100% of a PDF size?
- How can I print at 600 x 600 dpi? Test showed 300dpi and it is not clear where the settings are
1 post • Page 1 of 1