Hi,
I read before installing the demo that I could go back to earlier version by uninstalling the demo. The uninstall seemed to go cleanly but I cant get my printers to work again on v1.8
I was able to enter my turboprint.tpkey file and it shows like it is registered.
I have licence 100060506182309
Can you please confirm what version this should work with and where I can down load the software. Maybe my local copy got corrupted in the swap over.
Although it accpeted the file it seemed to be looking for a *key rather than *tpkey. I recall you changed things a one time , have I got my versions mixed up?
TIA.
PS sorry this should of course have gone in to turboprint section not Fab.
can't revert to v 1.8 after v2 demo
Hello,
after uninstallation of version 2 and reinstallation of version 1, TurboPrint 1 should work as before (as far as it is still the same old Linux distribution). Note that current Linux distributions will only work with TurboPrint 2 as most libraries have been changed.
We have stopped the support of TurboPrint 1 as it has been replaced more than two years ago.
after uninstallation of version 2 and reinstallation of version 1, TurboPrint 1 should work as before (as far as it is still the same old Linux distribution). Note that current Linux distributions will only work with TurboPrint 2 as most libraries have been changed.
We have stopped the support of TurboPrint 1 as it has been replaced more than two years ago.
thanks for the reply.
I did not have any library issues and the software was working just before I installed the v2 demo. So that is not the problem here.
I do not need detailed tech support at this stage since the software was working but I do not expect to find myself unable to use what I payed you for after following your advice that the demo would not break my existing installation.
Could you please answer my question as to which version the licence I purchased corresponds to and where I can download the tarball?
many thanks.
I did not have any library issues and the software was working just before I installed the v2 demo. So that is not the problem here.
I do not need detailed tech support at this stage since the software was working but I do not expect to find myself unable to use what I payed you for after following your advice that the demo would not break my existing installation.
Could you please answer my question as to which version the licence I purchased corresponds to and where I can download the tarball?
many thanks.
I may well still have the tarball or can find it elsewhere if you would so kind as to tell me what version of the software my licence applies to!
I recall that you changed the keyfiles at some stage during 1.x so I need to know upto what release I can use that with.
I'm not asking for tech support, I just want to know what version my license applies to. That would not seem too much to ask.
regards.
I recall that you changed the keyfiles at some stage during 1.x so I need to know upto what release I can use that with.
I'm not asking for tech support, I just want to know what version my license applies to. That would not seem too much to ask.
regards.