Please accept my apologies for my lack of knowledge and skills. My useful excuse is that at 80yrs I'm desperately trying slowdown the cursed dementia.
As I couldn't find an email address to forward the printed replies i received I'll just reprint the relevant extractions below in the hope that they may be of use to you and others.
"As we do not support linux sytems, I was quite surprised to find these instructions for the wireless LAN setup on our website. Please use the link below to view the instructions:
http://support-au.canon.com.au/contents ... 311100.htm
If you need to findtheIP address again instructions are as follows:
from your HOME scrssn press the up arrow to see the SETUP menu item, press the functionbutton underneath SETUP.
Press left or right arrow to find Device Settings
Press up or down to find LAN Settings
Press up or down to find Confirm LAN Settings
Select WLAN Setting list to view or Print list to print the settings.
If you require further information or assistance please contact Canon on 131383 and then option 2 or send an email to
cctechsupport@canon.com.au
and quote reference 00151086. "
The other printed result was devided into 3 sections which I'll endeavour to show below.
Canon MG200 Network Configuration Page
[Wireless LAN : Enable
Link Status : Active
MAC Address : 88:87:17:8A:7F:02
SSID : TP-LINK_E7FF48
Connection Mode : Infrastructure
Channel : 1
Encryption : AES
WEP Key Length : Inactive
Authenication : WPA2-PSK
Signal Strength : 100 [%]
TCP/IP Version : IPv4
IP Address : 192.168.1.101
Default Gateway : 192.168.1.1
Subnet Mask : 255.255.255.0
Subnet Prefix Length :
IPsec :
Security Protocol ;
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------[Wired LAN] : Disable
Link Status : Inactive
MAC : 88:87:17:^C:99:9C
TSP/IP Version :IPv4
IP Address :
Default Gateway :
Subnet Mask :
Subnet Prefix Length :
IPsec :
Securiry Protocol :
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------[Other Setting]
Printer Name : 8A7F02000000
Shared Memory Card : Enable
WSD : Enable
WSD Timeout : 1 [min]
LPR Protocol : Enable
Bonjour : Enable
Bonjour Service Name : Canon MG200 series
DNS Server : Auto
Primary Server : 192.168.1.1
Secondary Server :
Proxy Server : Disable
Proxy Port :
Proxy Address :
IP Address Filtering : Disable
Hope this is of use.
Regards,
Bernard.