Canon Pixma Pro 100 bjnp
Posted: Thu Feb 05, 2015 4:05 am
I just purchased a cannon pixma pro 100 and I am trying turbo print.
I am on linux Kubuntu 14.14
I am trying to print via the network and installed using bjnp. The printer receives a static ip from my router. I am able to install the printer fine through the turboprint control. But if I try to print a test page or any page at all, I receive the error in the turbo print monitor window "spooler message": "Unable to connect to printer; will retry in 30 seconds..."
This is the message that appears in the cups web interface as well.
In the turbo print monitor window it will sometimes show 5-8 percent complete spooling before the message appears.
I have been unable to print anything.
I am on linux Kubuntu 14.14
I am trying to print via the network and installed using bjnp. The printer receives a static ip from my router. I am able to install the printer fine through the turboprint control. But if I try to print a test page or any page at all, I receive the error in the turbo print monitor window "spooler message": "Unable to connect to printer; will retry in 30 seconds..."
This is the message that appears in the cups web interface as well.
In the turbo print monitor window it will sometimes show 5-8 percent complete spooling before the message appears.
I have been unable to print anything.