Page 1 of 1
How to perform an upgrade
Posted: Sat Aug 11, 2007 11:25 am
by Robban
Hi,
Just downloaded PrintFab v2.08 to upgrade my licensed version of PrintFab v2.06.
A question before I perform the upgrade.
Do I have to re-apply the license key and install the printer when doing the upgrade?
or ... will the installer notice that my current PrintFab has been registered and a printer has been defined => I don't have to redo anything (this would be the best).
br/rob
Posted: Mon Aug 13, 2007 8:37 am
by zedonet
Hello,
you will have to re-apply the license key (e.g. choose the license key file when requested by PrintFab Installer). You will not have to install the printer again - the driver and its settings will remain unchanged.
Posted: Mon Aug 31, 2009 3:14 pm
by nlx
Where to check the printfab version i'm using ?
Where to to download the last version ?
How to be informed of updates ? Newsletter ?
Posted: Tue Sep 01, 2009 9:56 am
by zedonet
Hello,
nlx wrote:Where to check the printfab version i'm using ?
Open PrintFab Toolbox (in the Applications folder), pull down menu "PrintFab Toolbox" -> "About PrintFab Toolbox"
nlx wrote:Where to to download the last version ?
http://www.printfab.net -> link "Download"
nlx wrote:How to be informed of updates ? Newsletter ?
Check
http://www.printfab.net
or
http://www.printfab.net/history.html
for version changes.
A newsletter and/or RSS feed is planned.
Posted: Tue Sep 01, 2009 10:16 am
by nlx
Thanks
It sounds a bit odd to have to download what you call a demo, to update the software.
+ in the installation process there is nothing that tell you you can update your software this wayâ¦
I think all this could be update to make it more clear (both the site and the install)