Align PixmaiP4600 problem
Posted: Tue Dec 02, 2008 9:23 pm
Hi,
I have problem when aligning my Pixma iP4600, I am doing i as it say that i should.
But when i am printing the picture is blurred.
So then i did it the other way around and got the picture better but still blurred.
The print shows very small squares so its hard to see the stripes all-right.
And to another thing the Align print head tool have a fault in the last pop up
It say that you should fill in Sections 97 to 101 from -5 to +5 and Section 102 to 106 -3 to+3 but the printed page is saying section a to j -2 to +2.
Is there a easier way to calibrate the printer???
I have problem when aligning my Pixma iP4600, I am doing i as it say that i should.
But when i am printing the picture is blurred.
So then i did it the other way around and got the picture better but still blurred.
The print shows very small squares so its hard to see the stripes all-right.
And to another thing the Align print head tool have a fault in the last pop up
It say that you should fill in Sections 97 to 101 from -5 to +5 and Section 102 to 106 -3 to+3 but the printed page is saying section a to j -2 to +2.
Is there a easier way to calibrate the printer???