Hello,
I am having persistent problems with many of the new versions of TurboPrint, at least the three latest.
My Canon MX7600 printer is connected over the network, and I have the same problem with Opensuse 11.0/11.1 64bit. The prints frequently fail. Either after about 25% of the page has been printed or when trying to duplex. The printer works perfectly in Windows.
I am fairly disappointed as I bought 3 copies with updates but the only version that nearly works is now old.
Can you help find the problem? What information should I post?
Thanks,
Philip
TurboPrint Problems with MX7600 Opensuse 64bit network
Hello,
thank you for your feedback!
This is probably a network problem - please try if printing with direct USB connection works reliably.
About the network printing setup:
Please check which "URI" is listed for your printer in TurboPrint Control Center (column "URI") and post the information.
If the URI starts with "bjnp://...", the BJNP (Canon Bubble Jet Network Protocol) is used - this is recommended.
In this case, please check which version of the BJNP network backend is installed on your system: open a "Terminal" window and enter the command
/usr/lib/cups/backend/bjnp --version
and post the information.
thank you for your feedback!
This is probably a network problem - please try if printing with direct USB connection works reliably.
About the network printing setup:
Please check which "URI" is listed for your printer in TurboPrint Control Center (column "URI") and post the information.
If the URI starts with "bjnp://...", the BJNP (Canon Bubble Jet Network Protocol) is used - this is recommended.
In this case, please check which version of the BJNP network backend is installed on your system: open a "Terminal" window and enter the command
/usr/lib/cups/backend/bjnp --version
and post the information.