TurboPrint & PrintFab

Hi, I have set up my Designjet 30 via usb from my MacBook Pro and ripping/printing is fine. However, when the printer gets to the end of printing a sheet it seems that the data is not carried across to release the paper for about 5 minutes! After this period, the printer will release the paper and start the next job in the PrintFab queue. Any ideas please as I can't use software that takes this long!

Hello,

how is the printer attached - usb or network?

If network connection: you could try to set up the printer with a different network protocol - recommended is "HP Jetdirect - Socket" (see also the PrintFab PDF manual, chapter 6).

Hello, thanks for the reply, it's attached via USB.