TurboPrint & PrintFab

Hello, a few days ago I had to re-install turboprint. All my settings were the same as before and everything appeared ready to go until today when I tried printing a simple pdf. I attempted to print from both GIMP and my basic image viewer.

The print monitor went through the usual motions of asking me to confirm the print job, spooling, transferring the data etc, but once it got to 100% it just said the job was completed; my printer tray didn't even move to pick up a sheet of paper!

Any help would be greatly appreciated.
Thanks
RC

Hello,

can you please send the following information:

- which Linux version & distribution do you use?
- how is the printer connected (direct USB connection or through network)?
- the "URI" displayed in TurboPrint Control, column "URI"
- the log file /var/log/turboprint/print.log, section for last print job starting from "### New print job..."