Espon Pro 4800 doesn't actually print
Posted: Thu Mar 18, 2010 9:58 pm
Hello, a few days ago I had to re-install turboprint. All my settings were the same as before and everything appeared ready to go until today when I tried printing a simple pdf. I attempted to print from both GIMP and my basic image viewer.
The print monitor went through the usual motions of asking me to confirm the print job, spooling, transferring the data etc, but once it got to 100% it just said the job was completed; my printer tray didn't even move to pick up a sheet of paper!
Any help would be greatly appreciated.
Thanks
RC
The print monitor went through the usual motions of asking me to confirm the print job, spooling, transferring the data etc, but once it got to 100% it just said the job was completed; my printer tray didn't even move to pick up a sheet of paper!
Any help would be greatly appreciated.
Thanks
RC