Color correction doesn't work
Posted: Thu Oct 11, 2018 9:00 am
Hello All,
my monitor is calibrated, and the printer profiled by Zedonet.
After the summer break I had to replace a lot of cartridges for my Pixma Pro 10s, and although now it prints well, I wanted to check the color balance with a test image.
It turned out to have less "red" than the image on display, so I thought I'd fine tune it in the driver.
However, no matter how much I pushed the slides in the Turboprint toolbox tabs (Color: Red or Correction: Magenta), the print came out just the same.
What am I missing?
Thanks for any advice,
-Gian
my monitor is calibrated, and the printer profiled by Zedonet.
After the summer break I had to replace a lot of cartridges for my Pixma Pro 10s, and although now it prints well, I wanted to check the color balance with a test image.
It turned out to have less "red" than the image on display, so I thought I'd fine tune it in the driver.
However, no matter how much I pushed the slides in the Turboprint toolbox tabs (Color: Red or Correction: Magenta), the print came out just the same.
What am I missing?
Thanks for any advice,
-Gian