designjet 90 and printer toolkit routines
Posted: Fri Oct 23, 2020 8:20 am
Morning,
PrintFab has solved my windows 10 issues with HP dropping driver support, which is wonderful, but is there any reason why the various button in the toolkit section would be greyed out, ie alignment, nozzle check, nozzle clean etc? Without these I have no way of maintaining print quality as I have no way of undertaking this from windows 10 directly. Is there an issue with the installation or are these not supported on this plotter under printfab, ie only if local rather than across network?
windows 10 workstation [ HPZ230 ] with designjet 90 connected over 1GB network using jetdirect internal card in Designjet 90
If I can get this issue resolved would be purchasing the full pro licence immediately.
thanks
PrintFab has solved my windows 10 issues with HP dropping driver support, which is wonderful, but is there any reason why the various button in the toolkit section would be greyed out, ie alignment, nozzle check, nozzle clean etc? Without these I have no way of maintaining print quality as I have no way of undertaking this from windows 10 directly. Is there an issue with the installation or are these not supported on this plotter under printfab, ie only if local rather than across network?
windows 10 workstation [ HPZ230 ] with designjet 90 connected over 1GB network using jetdirect internal card in Designjet 90
If I can get this issue resolved would be purchasing the full pro licence immediately.
thanks