Epson P50/T50 edge banding
Posted: Fri Nov 20, 2020 9:56 pm
Hi,
Using PrintFab for Windows I've experienced odd banding problem. Seems like similar issue was described few years ago in TurboPrint forum.
https://www.turboprint.info/support/viewtopic.php?f=4&t=2686
Pages printed with the PrintFab driver have little color mismatch on the beginning of printed pages, about 5-6 mm from the edge. Colors in that area have gradual brightness offset from little brighter (on the edge) to little darker (towards the middle of the page) than actually on the photo.
This happens for different weight, different brand photo papers (tested on 180, 200, 270, 300) but only when using PrintFab driver. Original Epson driver does no such thing.
I think I've tried it all already. Uni/bidirectional printing, different Platen Gap, both settings for Duplex Adjustment, different DPIs, ink intensity but nothing can be done to get rid of this when using PrintFab.
I've also calibrated anything I could on the printer itself. Apart from that 5-6 mm everything looks great.
I suppose this "effect" applies also to the other P50/T50-like printers, so all L8xx line. Seems like quite large market segment.
Are there any chances this issue will be fixed soon? Except for this, prints on PrintFab are quite amazing. Never thought my old P50 can print like that. Unfortunately this issue is a major flaw.
Using PrintFab for Windows I've experienced odd banding problem. Seems like similar issue was described few years ago in TurboPrint forum.
https://www.turboprint.info/support/viewtopic.php?f=4&t=2686
Pages printed with the PrintFab driver have little color mismatch on the beginning of printed pages, about 5-6 mm from the edge. Colors in that area have gradual brightness offset from little brighter (on the edge) to little darker (towards the middle of the page) than actually on the photo.
This happens for different weight, different brand photo papers (tested on 180, 200, 270, 300) but only when using PrintFab driver. Original Epson driver does no such thing.
I think I've tried it all already. Uni/bidirectional printing, different Platen Gap, both settings for Duplex Adjustment, different DPIs, ink intensity but nothing can be done to get rid of this when using PrintFab.
I've also calibrated anything I could on the printer itself. Apart from that 5-6 mm everything looks great.
I suppose this "effect" applies also to the other P50/T50-like printers, so all L8xx line. Seems like quite large market segment.
Are there any chances this issue will be fixed soon? Except for this, prints on PrintFab are quite amazing. Never thought my old P50 can print like that. Unfortunately this issue is a major flaw.