TurboPrint & PrintFab

I am trying out the trial version (Ubuntu 20.04) and i accidently selected Studio version on installation when I was intending to trial Pro one. I have tried uninstalling and reinstalling (from .deb and .tgz) but each time the studio version is assumed (obviously uninstalling doesn't remove everything). Is there anyway to change version? Also will this cause a problem if I were to subsequently purchase the Studio version?

Hello,

during the trial, the license type is configured in the file /etc/turboprint/system.cfg

You can change the following line

TP_DEMOTYPE=1

1=Pro
2=Studio
3=Studio XL

After installing a license, this setting is no longer relevant, so it is no problem to set the demo to "TurboPrint Pro" and purchase "TurboPrint Studio" later.