Page 1 of 1

daemon not started on Artix

Posted: Fri May 06, 2022 12:46 am
by TimPearce
I am running Turboprint on Artix Linux.

Artix is an Arch Linux derivative that uses openrc instead of systemd as it's init system.

The AUR install assumes that systemd is present but because I don't have systemd the daemon start does not work.

To solve my problem I created /etc/local.d/turboprint.start which is set as executable. It contains just '/usr/bin/tprintdaemon start'.

Once I fixed that it all works fine to print to the Toshiba eStudio. The only 'issue' I have now is working out which is the bypass feed in the interface.