TurboPrint & PrintFab

Hello,
I used the Demo version to successfully print 13 x 19 inches on matte paper. When the 30 days were over and I purchased a license, it no longer prints more than 9 inches wide. I tried uninstalling and re-installing, restarting, playing with print er settings for scale. I can print in full on legal. I had purchased this software because the i9900 is no longer supported with drivers and I love printing in large format. Any advice?

Hello merlot415,

PrintFab Home license is limited to a printing width of 9 inches, for wider prints at least PrintFab "Home L" is needed (see the comparison table of PrintFab versions on the web page, submenu "PrintFab Editions").
I will contact you by email for upgrade possibilities.