can't revert to v 1.8 after v2 demo
Posted: Sun Nov 07, 2010 4:32 pm
Hi,
I read before installing the demo that I could go back to earlier version by uninstalling the demo. The uninstall seemed to go cleanly but I cant get my printers to work again on v1.8
I was able to enter my turboprint.tpkey file and it shows like it is registered.
I have licence 100060506182309
Can you please confirm what version this should work with and where I can down load the software. Maybe my local copy got corrupted in the swap over.
Although it accpeted the file it seemed to be looking for a *key rather than *tpkey. I recall you changed things a one time , have I got my versions mixed up?
TIA.
PS sorry this should of course have gone in to turboprint section not Fab.
I read before installing the demo that I could go back to earlier version by uninstalling the demo. The uninstall seemed to go cleanly but I cant get my printers to work again on v1.8
I was able to enter my turboprint.tpkey file and it shows like it is registered.
I have licence 100060506182309
Can you please confirm what version this should work with and where I can down load the software. Maybe my local copy got corrupted in the swap over.
Although it accpeted the file it seemed to be looking for a *key rather than *tpkey. I recall you changed things a one time , have I got my versions mixed up?
TIA.
PS sorry this should of course have gone in to turboprint section not Fab.