TurboPrint & PrintFab

Hello!

My printer: Epson ET2865

My task: to print A4 without frames (borderless).
I launch Printfab, for my printer I use driver 2860.
I set the settings to print A4 borderless (oh, nice).

The printer starts printing, paper with an image without frames comes out, but when the printing reaches about 70%, the paper stops moving and the printer starts making printing sounds, but the paper does not go anywhere, and so on endlessly. I turn off the printer so that the paper comes out.

I tried to use other drivers, 2870, 2810, but it does not help, the problem is the same everywhere.
If I printing with frames - there is no such problem, the sheet is printed completely.

How can I fix it?

Hello, this has not been observed or reported yet so I have no immediate solution. You wrote "the printer starts making sounds" - is the print head moving? When you force the paper out by turning the printer off and on again, it the page complete or is about 30% of the print missing?