TurboPrint & PrintFab

Posted: **Mon Oct 13, 2025 5:25 pm**

Installing TurboPrint 2.57-1 installation on LinuxMint 22 fails while running setup.h:

./setup.sh
./setup.sh: line 48 bin/turboprint: cannot execute: required file not found
Could not start X-Windows installation tool.
make sure that X-Windows is running and accessible

Linux is recently installed but seems stable. I am following instructions in text file INSTALLATION.

Posted: **Thu Oct 16, 2025 7:36 am**

Hello, I think that a library is missing that is required by TurboPrint, e.g. gtk2.

Installation can be done from Terminal with the command line

Code: Select all

sudo apt-get install gtk2.0

Posted: **Sat Dec 06, 2025 8:54 pm**

Thank you for support. After a disk failure I lost anything related to TurboPrint. So I purchased TurboPrint for Linux again today and installed it. I can now print but my prints include a conspicuous message that I am using your "FreeEdition" and must purchase a license a license key. So, my paid edition may be unable to find my license key. Please advise.

Posted: **Tue Dec 16, 2025 2:44 pm**

[This question been answered & solved by email]

Remark for similar questions: For license specific topics please contact us using the contact form or by email.

TurboPrint & PrintFab

[SOLVED] setup.sh : "Could not start X_WINDOWS installation tool."

[SOLVED] setup.sh : "Could not start X_WINDOWS installation tool."

Re: setup.sh : "Could not start X_WINDOWS installation tool."

Re: setup.sh : "Could not start X_WINDOWS installation tool."

Re: setup.sh : "Could not start X_WINDOWS installation tool."