SuSE 9.0 and 10.0 problems with gimp

Linux distribution specific questions
Post Reply
Jim Sabatke
Posts: 3
Joined: Sun Nov 05, 2006 7:31 am

SuSE 9.0 and 10.0 problems with gimp

Post by Jim Sabatke » Sun Nov 05, 2006 11:50 pm

I can print the test page fine.

From gimp (2.2.4) or (1.2.5) all I get is ASCII instead of Postscript output. I've gone through the setup gyrations listed on the Turboprint site related to gimp and no go.

I'm going crazy with this and I'm sure it's something simple I'm doing wrong, but I don't know what it is.

TIA

Jim

zedonet
Site Admin
Posts: 1782
Joined: Fri Oct 06, 2006 8:02 am

Post by zedonet » Mon Nov 06, 2006 8:47 am

Please check the print command in the GIMP print dialog. There should be no "-o raw" option, e.g. change

lp -d tp0 -o raw

into

lp -d tp0

Which printer are you using?

Jim Sabatke
Posts: 3
Joined: Sun Nov 05, 2006 7:31 am

Post by Jim Sabatke » Mon Nov 06, 2006 8:48 pm

I'm using an Epson Sylus Photo R800.

I think I've got everything working after deleting everything, starting over and then rebooting the server.

Thanks for the response.

Jim

primer
Posts: 10
Joined: Mon Oct 30, 2006 9:22 pm

Post by primer » Mon Dec 25, 2006 3:11 am

hey, thanks for the forum, I've been banging my head against this for 2 days.

dumb-assed gimp-2.2 keeps adding -o raw everytime I look at the printer setup and a hint pops up telling me not to remove it !!

If that happens all the time you probably need to add a waring to the install instructions.

8)

Post Reply